Bosch HBN 43M 550 A - Manual (Page 52)

52
Assembly Instructions
For the installer
and kitchen expert!
Important installation
Properly dispose of packaging materials.
notes
Do not use oven door handle for
transporting or handling the unit during
installation.
WARNING: Connection and first start of the
appliance may only be performed by an
authorised specialist.
Connection must be made using an
H 0 5 R R - F 3 G 1,5 mains connection cable.
Rated consumption, rated voltage and type
no. of the appliance:
See appliance nameplate behind the oven door
to the left beneath the side edge of the oven.
The unit's nameplate is located at on the
sidewall of the unit.
Electrical safety of the appliance can be ensured
only if the equipment earth in the building
installation has been installed according to
regulations.
On the installation side a separating device shall
be provided. Any switch with a contact gap
The connection diagramm is exceeding 3 mm may be considered a separating
located on the rear panel of the device. Other examples are LS switches, fuses
appliance. and contactors.
In the case of repairs interrupt all power
connections to the unit.
The properly installed appliance must be covered
on all sides in such a fashion that not even
components with rough insulation are exposed to
the touch.
The cover must be removable with tools only.
220-240V ~ L N