Blaupunkt Sydney RCM 126 User Manual
Page 16
Connect the brown “GROUND+” lead to a grounded metal part on the vehicle. We recommend
grounding all audio system ground leads (receiver, external amplifier, etc.) to a common
grounding point, preferably a non-painted surface under the instrument panel.
brown ground
Connect the red lead designated “BATTERY
to a source of constant battery power.
Connect the red lead designated as “ACC
“IGNITION” (turn-on power) only after the
other leads are connected. Be sure to connect the red lead to a positive (+) 12 Volt power
terminal that is energized only when the ignition key is set to the on position or accessory
position.
8.
9.
Cover the ends of any unused leads with electrical tape. This will prevent them from touching
the vehicle or each other and causing a short-circuit and damage to the unit or vehicle.
Reconnect the vehicle’s battery.
10.
that no fuses have blown.
11. Plug the harness
the unit.
12. Attach the antenna “elbow” and affixing bracket to the back of the unit. Insert your vehicle’s
antenna.
Test the unit. Once the connections have been successfully made, you can begin to install the unit
3