Blaupunkt Sydney RCM 126 - Manual (Page 5)

PTY (Program Type)
In the PTY mode, the preset buttons
become program type buttons. With
each preset you can select one pro-
gram type, such as for example
NEWS, SPORT, ROCK, CLASSICL,
etc.
SRC (source)
You can switch between the different
audio sources radio, tape, and
AUX (if activated).
DIS
Radio ooeration
When an RDS station is received,
press the button and the frequen-
cy will be displayed for approximately
four seconds.
When pressing the DIS button, the sta-
tion name or frequency will be dis-
played for approximately four seconds.
Loudness When listening at a low
level, the Loudness function creates a
more natural sound by boosting the
low frequency range.
LD on/off: Press the button.
When the Loudness function is active,
will light up in the display.
See chapter programming” for
more information.
DSC (Direct Software Control)
Use the DSC function to
certain programmable, basic settings
to suit your personal needs and prefer-
ences. See chapter “DSC
for more information.
Chanaer operation (optional)
To switch the display mode and select
between name, time (playback time)
and number (disc number):
l
Press briefly.
(Radio Monitor)
Press this button to listen to the radio
while fast forwarding or rewinding the
tape.
To switch RM on/off: Press RM.
When this function has been activated,
“RM” shows on the display panel.
The radio is played back during fast
tape run.
to eject the tape.
1, 4, 5, 6 preset buttons
On FM, you can store six stations for
each of the memory banks I, II and T.
On AM, you can store six stations.
To store a station: Press a preset
button during radio operation and hold
down until the set resumes play after
the muting and you hear a beep.
To recall a station: Select the desired
waveband. On FM, also adjust the
corresponding memory bank. Then
press the relevant preset button briefly.
Extra function for preset buttons
To store and recall a PTY program
type.
On FM, vou can store and recall one
program-type on/from each preset but-
ton when PTY is active (“PTY”
lights up in the display).
Cassette loading slot
Insert the tape with side A or 1 facing
up, the open side showing to the right.
Tape side selector
Press this button to switch over to the
other side during tape operation. The
display shows “TR 1” or “TR 2”.
Dolby B
Press this button to play back a tape
which has been recorded with Dolby-B
noise reduction. When this button is
pressed, “B“ lights up in the display.
Noise Reduction system manufactured under li-
cense from Dolby Laboratories Licensing Cor-
poration, “Dolby“ and the double-D symbol are
trademarks of Dolby Laboratories Licensing
poration.
AUD
To adjust the balance (left/right) and To adjust the treble and bass
fader (front/rear) with the rocker with the rocker switch.
switch.
Fader front
V Fader rear
B a l a n c e l e f t
>> Balance right
The last setting will be stored automat-
ically.
To switch off GEO: Press button once
again.
If the setting remains unchanged
within four seconds, the display will
switch back to the previous condition._
Treble +
V
Treble
B a s s
B a s s +
The last setting will be stored automat-
ically.
To switch off AUD: Press button once
again.
If the setting remains unchanged with-
in four seconds, the AUD setting will
be terminated automatically.
10