Brother DCP-J525W - Manual (Page 27)

Configuring your machine for a wireless network
23
3
Configuration using the machine’s control panel Setup
Wizard
3
You can use the machine’s control panel to configure your wireless network settings. By using the control
panel Setup Wizard function, you can easily connect your Brother machine to your wireless network. You
must know your wireless network settings before you proceed with this installation.
IMPORTANT
If you have previously configured the wireless settings of the machine, you must reset the LAN settings
before you can configure the wireless settings again.
To reset the LAN settings, see Restoring the network settings to factory default uu page 41.
Manual configuration from the control panel
3
For MFC-J425W/J430W/J432W/J435W
3
a Before configuring your machine we recommend you write down your wireless network settings. You will
need this information before you continue with the configuration.
b Press Menu.
c Press a or b to choose Network.
Press OK.
d Press a or b to choose Setup Wizard.
Press OK.
e When Enable WLAN? is displayed, press OK to accept.
This will start the wireless setup wizard.
To cancel, press Stop/Exit.
Item Record the current wireless network settings
SSID (Network Name):
Network Key