Bogen LUMDMU - Manual (Page 14)

Playing Messages in Sequence
A group or sequence of messages can be played to the output channel.
The maximum number of messages in a sequence can be up to 8
(determined by the DIP switch settings on the back panel). To add
messages to the sequence simply repeat the PLAY command, selecting
the message to be added each time.
1
2
3
4
5
Press the FUNC button until PLAY is displayed.
PLAY
Press the RUN button.
MSG-01
The first message is displayed.
Press the FUNC button to select a message other
than MSG-01 to play in:
MSG-09
Press RUN to play (and group) the message.
PLY-S09
Ply = Play, S = sequence message #9.
Repeat steps 1 through 4 to add up to 8 messages if
you are configured for 8 (see page 9).
11
NOTE: If a contact closure
comes in on the RJ-21 cable,
the message sequence will
stop. The contact closure
message will play until the
closure is removed. The
sequence message will resume
where it left off.