Liebherr WTes 5972 Vinidor - Manual (Page 6)

16
Interior light
The interior of the appliance is lit by an LED light strip at the top
of each compartment.
The interior light will always switch on when the appliance door
is opened.
The interior light will go out approx. 5 seconds after the door is
closed.
Press the Light button if you want the interior light to be
on even when the door is closed.
Note
This function applies to the lighting of both compartments.
Furthermore, the brightness of the lighting can be adjusted.
• Press the Light button.
• Press and hold the Light button
and at the same time press the
temperature setting buttons to in-
crease or decrease the brightness.
Note: The brightness will change in all compartments.
The light intensity of the LED light corresponds to laser
class 1/1M.
Important
The light cover may only be removed by customer service
staff. If the cover is removed, do not look directly at the
light through optical lenses from close distance. This can
damage your eyes.
Air exchange with activated charcoal
filter
The way in which wines continue
to mature depends on the ambient
conditions. The quality of the air is
therefore decisive for preserving
the wine.
We recommend that you replace the
illustrated filter once a year. Filters
can be obtained from your dealer.
Changing the filter:
Take the filter by the handle. Turn it
90° to the left or right and remove.
Inserting the filter:
Insert with the handle in a vertical
position. Turn it 90° to the left or right
until it clicks into place.
Safety lock
The lock in the appliance door is
equipped with a safety mechanism.
Locking the appliance:
• Insert the key as shown by arrow 1.
• Turn the key 180°.
To unlock the appliance, the same
procedure must be repeated in the
same order.
Adjusting the display brightness
Press for 5 seconds. Display =
Display =
Display =
Use buttons Up and Down to select the
desired setting.
h0 = display lighting off
h1 = minimum brightness
h5 = maximum brightness
Display =
Display =
The adjusted brightness will be activated after one minute.
Note
If a button is pressed, the display lights up for one minute at
maximum brightness.
Demo mode
Demo mode can be activated for presenting the appliance at
exhibitions or in salesrooms as though in normal operating mode.
DEMO appears in the display.
When in this mode, the cooling circuit is switched off!
If this mode is activated by accident, it can be deactivated as
detailed below.
Press + for 5 seconds. Display =
Display =
Display =
The refrigeration unit switches on.
The temperature display flashes.
The appliance is now in normal operating mode.