Liebherr WTes 5972 Vinidor - Manual (Page 7)

17
GB
Number of bottles
7
24
7
24
24
40
Total 211 bottles
24
13
24
24
Storage diagram
for 0.75 l Bordeaux bottles to standard NF H 35-124
Labels
The appliance is supplied with one
label for each wooden shelf.
Use these to label the type of wine
stored on each shelf.
Additional labels can be obtained from
your dealer.
Click the label holder into place and
slide the label in from the side.
Important
The maximum load per wooden shelf is 35 kg.
Presentation shelf
The middle pull-out shelf in the top compartment can be used
for the presentation of wine bottles or to keep opened bottles at
the perfect temperature. The presentation shelf can be used in
both zones.
The wooden shelf above it must
be removed so that the presenta-
tion shelf can be used. Raise and
remove the shelf.
Pull the presentation shelf for-
wards as far as it will go.
The front section of the pres-
entation shelf consists of two
segments which can be raised
separately.
Raise the segment and pivot the two supports
downwards.
Bottles can be stored behind the
raised segment.
Inserting the wooden shelf
Fit the upper wooden shelf again for using the presentation shelf
for storing bottles normally (with the segments not raised).
Extend the pull-out rails as far as they will go.
Place the wooden shelf with its bore holes face down on the pins
on the pull-out rails.