Philips ErgoFit Beutelloser Staubsauger - Manual (Page 12)

- The infrared-active light flashes when you press a button on the
remote control.
using the appliance
1 Pull the cord out of the appliance and put the mains plug in the wall
socket.
2 Press the on/off button on top of the appliance to switch on the
appliance.
Tip: To avoid bending your back, press the on/off button with your foot.
, The vacuum cleaner starts operating at the highest suction power
level.
3 To switch off the appliance, press the on/off button on top of the
appliance or the standby button on the remote control.
adjusting suction power
1 During vacuuming, you can adjust the suction power level with the
– and + buttons on the remote control.
- Use maximum suction power to vacuum very dirty carpets and hard
floors.
- Use minimum suction power to vacuum curtains, tablecloths etc.
pausing during use
1 If you want to pause for a moment, press the standby button on the
remote control to switch off the appliance temporarily.
2 Insert the ridge on the nozzle into the parking slot to park the tube
in a convenient position.
3 To ensure stable parking of the telescopic tube, adjust the tube to
the shortest length.
4 To continue vacuum cleaning, simply press the standby button on the
remote control again.
Cleaning the filter cylinder
A clean filter cylinder helps maintain high suction power.
After every vacuuming session, clean the filter cylinder in the way described
below.
Always leave the hose connected to the appliance during the filter-
cleaning process to prevent dust from coming out of the appliance.
English
12