Body Solid G6B - Manual (Page 20)

6
Be careful to assemble all components
in the sequence they are presented.
mm
Inch
20
S T E P
NOTE:
LEG EXTENSION FRAME (V) AND THE SEAT PAD FRAME (W) ARE PRE-ASSEMBLED AS
ONE PIECE.
A. Attach Leg Extension Frame (V) to Angled Support Frame (D) using:
Two 40 (1/2” x 3 1/4” hex head bolt)
Four 73 (1/2” washer)
Two 70 (1/2” nylon lock nut)
B. Attach the bottom of Leg Extension Frame (V) to Main Base Frame (A) using:
One 44 (1/2” x 5 1/2” hex head bolt)
Two 73 (1/2” washer)
One 70 (1/2” nylon lock nut)
C. Attach Leg Extention Arm (X) to Leg Extension Frame (V) with pre-installed Shaft (47) as shown
using:
Two 49 (5/16” x 1/2” round allen head bolt)
Two 76 (5/16” washer)
D. Tighten the two Allen Screws (34) to lock down Shaft (47) in Leg Extension Frame (V).
Attach two Convex End Caps (2) one to the top of Leg Extension Frame (V) and one to the top of
the Leg Extension Arm (X) as shown.
E. Attach Lock Down Hook (152) to Leg Extension Frame (V) as shown in the REVERSE SIDE
DRAWING using:
One 57 (3/8” x 2 1/2” hex head bolt)
Two 73 (1/2” washer)
One 153 (5/16” wide spacer)
F. Attach Leg Extension Pad Holder (Y) and 1/4” Wide Spacer (154) to Leg Extension Arm (X) using:
One 150 (1/2” x 4 1/2” hex head bolt)
Three 73 (1/2” washer)
One 70 (1/2” nylon lock nut)
G. Attach Leg Pads (AA) to Leg Extension Pad Holder (Y) using:
Four 61 (5/16” x 3/4” round allen head bolt)*
Four 77 (5/16” spring lock washer)
Four 76 (5/16” washer)
*Do NOT over-tighten these bolts. Tighten these bolts until spring lock washer is flat.
Over - tightening these bolts will cause T - nuts in pads to strip out.
Note:
You should now wrench tighten all bolts and nuts in this step.
Do NOT re-tighten any of the pad bolts.