Body Solid G6B - Manual (Page 38)

15
Be careful to assemble all components
in the sequence they are presented.
S T E P
38
NOW IS THE TIME TO MAKE ALL NECESSARY
CABLE ADJUSTMENTS
After cable installation is complete you must check all cables for proper tension. Obvious signs that
cable tension problems exist include:
Top Plate (17) does not rest directly on the top Weight Stack Plate (38).
The holes in the Selector Bar (19) do not line up with holes in the Weight Stack Plates (38).
Cable(s) are sloppy and there is no resistance from the weight stack for the first few
inches of the exercise.
There are FIVE areas for cable adjustment on the G6B:
A. Selector Rod Top Bolt (103).*
B. TWO adjustments in Double Pulley Holder (CA).
C. TWO Rubber Stops (98) and (155).
*SEE NOTE 1 ON PAGE 39
If there is to much tension, and the Top Plate (17) is not resting directly on the top weight stack plate:
1st. -Move pulley (A7) up, or Pulley (B3) down in the Double Pulley Holder (CA).
2nd. Turn and tighten one of the Rubber Stops (98) and (155).
If there is to much play or excessive slack:
1st. -Turn and loosen the Rubber Stops (98) and (155).
2nd. Move Pulley (A7) down, or Pulley (B3) up in the Double Pulley Holder (CA).
3rd. -Screw the Selector Rod Top Bolt (103) farther into the Selector Rod (19).
NOTE:
Cables should be inspected daily and adjusted periodically to ensure safe and
smooth operation.
NOTE:
After cable adjustment is complete, go back and tighten all pulley bolts.