Philips Kaffeevollautomat - Manual (Page 8)

K Control panel
1 3 On/off button
2 Button to select coffee strength and to select ground coffee
3 Button for one or two cups of short coffee
4 Button for one or two cups of standard coffee
5 Button for one or two cups of long coffee
6 Button for hot water
7 Button for automatic latte macchiato or frothed milk
8 Button for automatic cappuccino or frothed milk
L Removable water tank
M Milk jug lid
N CLEAN button
O Release button
P Milk jug
getting started
Before first use
Never install the appliance in environments where the temperature
may drop to 0° or below. If the water inside the appliance freezes, the
appliance will be damaged.
Note: It is normal that there are some traces of coffee and water in the
appliance when you use it for the first time. This is because the appliance has
been tested in the factory to make sure it is in perfect working order.
Note: If there is a sticker on the display, remove the sticker before you install
the appliance.
1 Place the appliance on a table or worktop away from the tap, the sink
and heat sources.
2 Leave a free space of at least 10cm above, behind and on both sides
of the appliance.
3 Carefully follow the step-by-step instructions in the following
chapter to learn how to use the appliance correctly.
Preparing for use
1 Put the plug in an earthed wall socket and wait.
, Different languages appear on the display.
2 Press the OK button for 3 seconds when the desired language
appears.
, The appliance automatically exits the MENU mode.
, The message ‘NO WATER! Fill water tank’ appears on the display.
EnglisH
8
4222.002.6507.7.indd 8 31-08-09 17:45