TC Electronic VSS3 TDM - Manual (Page 10)

EE
NN
GG
LL
II
SS
HH
10 / VSS3
Pre Delay
Range: 0 to 100ms
A delay placed at the input of the algorithm. This parameter defines how long after
the dry sound the Early Reflections and the diffuse field will begin.
Hi Cut
Range: 20Hz to 20kHz
Rolls off the top end as it enters the Reverb. Used in conjunction with Hi Soften and
Hi Decay to "darken" a room.
Hi Decay
Multiplier Range: 0.01 to 2.5
Sets the Decay time for the High-end frequencies of the Reverb diffuse field.
Levels
Rev Level
Range: Off, -97dB to 0dB
The output level of the diffuse field part of the algorithm. When Rev Level is set to
"Off", the effect will consist entirely of Early Reflections.
Early Level
Range: Off, -97dB to 0dB
The output level of the Early Reflections. When Early Level is set to "Off" the Reverb
effect will consist entirely of Reverb Tail.
Dry Level
Range: Off, -97dB to 0dB
Attenuates the Dry signal level on the output of the plug-in, thus leaving the Reverb
and Early Levels unaffected. "Off" equals a "kill-dry" setting.
The lock in the lower right corner of the control will prevent this parameter from being
updated by preset changes initiated from within the plug-in UI. All other actions (like
preset changes and automation data from the host) will pass and re-open the lock.
In Level
Range: Off, -97dB to 0dB
Sets the Input Level for the algorithm.
Out Level
Range: Off, -97dB to 0dB
The overall Output level of the Reverb. Use this parameter to adjust the output level
to fit for following effects in your host application.