TC Electronic VSS3 TDM - Manual (Page 15)

VSS3 / 15
EE
NN
GG
LL
II
SS
HH
Lo Mid Decay
Multiplier Range: 0.01 to 2.5
The Ratio control multiplier for the low-mid frequencies.
Mid Xover
Range: 200Hz to 2kHz
Sets the frequency at which the transition from the low-mid to the mid frequencies
takes place.
Hi Mid Decay
Multiplier Range: 0.01 - 2.5
The Ratio control multiplier for the mid frequencies. This parameter is normally set to
1.0 as it is the main parameter adjusted by the main Decay parameter. This mid-range
decay control would normally be omitted, however, TC Engineers felt you could use
this parameter as a fine adjustment tool to "tweak" a preset to sound just right without
having to adjust the master Decay parameter.
Hi Xover
Range: 500Hz to 20kHz
Sets the frequency at which the transition from the mid frequencies to the high fre-
quencies takes place.
Hi Decay
Range: 0.01 to 2.5
Multiplier for the frequencies above the Hi Xover frequency.
Example: If the main Decay parameter is set to 2.0sec and the Hi Decay parameter is
set to 1.5, frequencies above the Hi-Xover will decay for 3.0 sec. Conversely if this
parameter is set to 0.5 the Decay time above the Hi Xover point will be 1 sec.