Binatone SC2050 - Manual (Page 32)

31
Make sure the batteries are fitted in your handset. If
the Battery Level symbol on the display shows ‘low’,
recharge the batteries.
The keypad may be locked. Look for a on the display.
If it’s there, unlock the keypad by pressing and holding
the #/LOCK button.
Try moving the handset closer to the base telephone.
Try a different position for the base telephone, making
sure it’s not too near to any other electrical equipment.
Check that the base telephone’s mains power adapter
is plugged in and power is switched on.
Make sure you’re using the telephone line cable that
was supplied with your Big Button Combo. Other
telephone line cables might not work.
Check that you have not set the ringer volume to Off.
Check that the total REN value of all equipment connected
to your telephone line is no more than 4. Disconnect one or
more telephones and see whether that helps.
Move the cordless handset closer to the base telephone
before you try again to make a call.
Move the cordless handset closer to the base telephone, or
to a different position.
Try moving the base telephone so that it’s not near other
electrical equipment, such as a television or a computer.
Try a different position for the base telephone, making
sure it’s not too near to any other electrical equipment.
“When I press
keys on the
cordless handset,
nothing happens.”
“When I press
keys, digits
appear on the
display, but I
can’t make a call”
“The phone
does not ring”
“My call was cut
off when I went
out of range of
the base unit.
Now I can’t use
my handset.”
“There is
interference
and noise on
the line.”
Troubleshooting