Boca Research Turbo Series - Manual (Page 16)

16
IO Turbo Series
2. Insert the board in the slot you
have selected so the edge
connector on the bottom rear of
the board mates with the socket
on the motherboard. Press down
firmly on the board. Use the
removed screw to secure the
board.
3. Replace any other adapter boards you may have removed
and re-attach any detached internal cables. If you have the
Turbo 2x2 version, continue with step 4. Otherwise, skip to
step 5.
4. Attach cable/bracket assembly to Serial B and Parallel B
connectors on the IO board, making sure that the red stripe
plugs into pin number “1” on the board connector. After
removing screw and, for the Turbo 2x2, adjacent rear slot
cover, secure the bracket using the screw you just removed.
5. Replace the system cover taking care not to let it catch on
the disk drive or power cables. Once the cover is in place,
replace all the screws that you removed earlier. Reconnect
any previously removed external cables.
9361.p65 2/11/99, 11:02 AM 16