Boca Research Turbo Series - Manual (Page 25)

25 25 25 25 25
Section Four: Windows 3.x/DOS
Configuration
1. Power up your system as you normally would. If your
system boots into Windows, exit to DOS.
2. Insert the driver diskette. Go to the A:\ prompt, type
INST INST INST INST INSTALL ALL ALL ALL ALL and press ENTER.
IF A IF A IF A IF A IF A PLUG AND PLA PLUG AND PLA PLUG AND PLA PLUG AND PLA PLUG AND PLAY SYSTEM IS DETECTED Y SYSTEM IS DETECTED Y SYSTEM IS DETECTED Y SYSTEM IS DETECTED Y SYSTEM IS DETECTED , continue
below (for non Plug and play, continue with page 26).
1. A screen is displayed informing you that your Plug and
Play system has detected the new I/O Turbo Series board.
2. You may use your own Plug and Play configuration utility,
or select “Install the Locate Utility” “Install the Locate Utility” “Install the Locate Utility” “Install the Locate Utility” “Install the Locate Utility” to determine how
your system configured the I/O Turbo Series board.
3. You will be asked to indicate which operating system you
have:
• Windows 3.1, 3.11, Windows for Workgroups 3.11
• DOS
Follow all on-screen directions. Files are then copied to your
hard drive. If you are running Windows, you are asked if
you want to update your WIN.INI file. Select Yes.
You have the option of re-installing and selecting IOSETUP
to change settings which were assigned to the new device.
This will require a working knowledge of COM/LPT port
and IRQ settings and how these resources are assigned in
your system.
Driver Installation
9361.p65 2/11/99, 11:02 AM 25