B&B Electronics ESP904 User Manual
Page 13
Installing the VLINX ESP Software
Manual Documentation Number: ESP904-0504
Chapter 2
15
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
RS-232 Mode
In
RS-232 Mode
the serial port is configured to support eight RS-232 signal
lines plus Signal Ground and is configured as DTE like a computer. Signals
are single ended and referenced to Ground. To use handshaking, Flow
Control must be set to RTS/CTS during Configuration.
N
N
o
o
t
t
e
e
:
:
Refer to Appendix A for RS-232 connection pin-outs.
RS-422 Mode
RS-422 Mode
supports four RS-422 signal channels with full duplex
operation for
Receive
,
Transmit
,
RTS
(Request To Send) and
CTS
(Clear To
Send). The data lines are differential pairs (A & B) in which the B lines
positive relative to the A lines. Ground provides a common mode reference.
To use handshaking Flow Control must be set to RTS/CTS during
configuration.
N
N
o
o
t
t
e
e
:
:
Refer to Appendix B RS-422 connection pin-outs.
RS-485 Mode
RS-485 Mode
supports the transmit (TX) and receive (RX) signal channels
using 2-wire, half-duplex operation. The data lines are differential with the
Data B line positive relative to Data A in the Mark state. Ground provides a
common mode reference.
N
N
o
o
t
t
e
e
:
:
Refer to Appendix C for RS-485 connection pin-outs.
RS-485 Receiver Biasing
can be implemented from the ESP904 if the
network does not supply it. Remove the two side-cover screws of the
ESP904, slide the cover off and re-position the bias jumpers (shown open in
the figure below) to enable biasing (shorting).
Installing the VLINX ESP Software
16
Chapter 2
Manual Documentation Number: ESP904-0504
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics Ltd – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Figure 10. Internal Setting to Select RS-485 Bias
N
N
o
o
t
t
e
e
:
:
(For more information on RS-485 Receiver Biasing, see B&B Electronics RS-
422/485 Application Note available at
www.bb-elec.com
)