Braun 403 - Manual (Page 5)

Braun Corporation FMVSS No. 403 Quick Reference Installation Sheet 32494
Lift Operating Instructions
L
N M
approximately 2”
P
UP
O
J I
F
E
D
A
C
B
DOWN
G H
K
To Open Door(s):
Automatic Door Operator(s):
Press yellow OPEN switch until
door(s) are fully open. Release
switch.
Manual Door(s):
Manually open door(s) fully and
secure.
To Unfold Platform (Out):
Press UNFOLD (orange OUT)
switch (see Photo B) until platform
stops (unfolds fully – reaches
floor level). See Photos C and D.
Release switch.
To Unload Passenger:
1. Read notes below! Load passen-
ger onto platform facing outward
and lock wheelchair brakes.
Note: Outer barrier must be UP
and outer barrier latch must be
fully engaged before loading pas-
senger onto platform. Lower head
to clear vehicle door jamb header.
2. Press red DOWN switch until the
entire platform reaches ground
level (stops) and outer barrier
unfolds fully (see Photos H and I).
Release switch.
Switch Arm Switch: Slide knob in
to DOWN position. See Photo G.
3. Unlock wheelchair brakes and
unload passenger from platform.
Note: Outer barrier must be fully
unfolded (ramp position) until the
entire wheelchair has crossed the
outer barrier. See Photos K and L.
To Load Passenger:
1. Load passenger onto platform fac-
ing outward and lock wheelchair
brakes.
Note: Outer barrier must be fully
unfolded (ramp position) until the
entire wheelchair has crossed the
outer barrier. See Photos K and L.
2. Press red UP switch until platform
stops (reaches floor level). Re-
lease switch.
Switch Arm Switch: Slide knob out
to UP position.
Note: Outer barrier must be
UP and outer barrier latch must
be fully engaged before raising
platform. Platform will raise above
ground level approximately two
inches before latch engages fully.