Philips 711902324 - Manual (Page 18)

Vedi
targhetta dati
INSTALLATION / VENTILATE
Check that all components
are correctly placed.
0RYHWKH212))VZLWFKWR
“I” to turn on the machine. Place a container beneath
the steam tube. Rotate the knob to start
loading the circuit.
Wait until a steady stream
RIZDWHUÀRZVRXWIURPWKH
nozzle. Put the knob again in the
central position to end the
circuit loading. The machine is ready for
use when the light is stea-
dily lit.
Fill the tank with fresh drin-
king water.
See rating
plate
Remove the container.
Remove the lid and take
the water tank out. Fit the water tank and
place the lid again.
The machine is warming up;
WKHOLJKWLVÀDVKLQJ
Flashing
7KHPHVVDJHVGLVSOD\HGE\WKHPDFKLQHGXULQJRSHUDWLRQDUHVKRZQRQSJ
Steadily lit
INST
ALLA
TION
Put the plug into the soc-
ket placed on the machine
rear.
Connect the plug placed at
the opposite side of the ca-
ble to an adequate socket.
Green
Green
Note: You must load the circuit
before starting up the machine
IRU WKH ÀUVW WLPH LI LW KDV EHHQ
LQRSHUDWLYH IRU D OHQJWK\ SHULRG
RU LI WKH ZDWHU WDQN KDV EHHQ
completely emptied. The circuit
must be al-
so loaded
each time
the light is
steadily lit:
Steadily lit
18