ARB WINCH BULL BAR - Manual (Page 10)

Last Rev Date: 11/05/2009 Page 10 of 13 Fitting instructions# 3786410
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
32. With the help of an assistant position the bull
bar on the chassis bracket and fix with six
M10 x 30mm bolts, M10 spring and flat
washers.
CAUTION: Nip up bolts, but do not tighten
them yet.
33. Position the bull bar so that there is an even
gap of approximately 20-25mm from the top
face of the bar to the underside of the body
edge. Then tighten all the bolts.
34. With the bull bar in position drill Dia10mm
pinning holes, one though pilot hole in mount
bracket and one through hole in upright for
both sides of mounts.
35. Fix in place using two M10 x 30mm SEMS
bolts, M10 Flat washers and M10 x 1.5 nuts
per side.
36. Fit the bull bar stone tray by sliding the tray
under the front of the vehicles original stone
tray and fixing in place with the original bolts
from the vehicles stone tray.
37. Fit the front of the stone tray to the bull bar
with four M6 x 20mm bolts, M6 large panel
washers and M6 spring washers.
FITTING PROCEDURE
Warning: Drilling operations can result in
flying metal debris, safety glasses should be