General care and maintenance, Fitting requirements – ARB WINCH BULL BAR User Manual
Page 2
Last Rev Date: 11/05/2009
Page 2 of 13
Fitting instructions# 3786410
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
GENERAL CARE AND MAINTENANCE
By
choosing an ARB Bar, you have bought a product that is one of the most sought after 4WD products in
the world. Your bar is a properly engineered, reliable, quality accessory that represents excellent value.
To keep your bar in original condition it is important to care and maintain it following these
recommendations:
Prior to exposure to the weather your bar should be treated to a Canuba based polish on all exposed
surfaces. It is recommended that this is performed on a six monthly basis or following exposure to
salt, mud, sand or other contaminants.
As part of any Pre Trip Preparation, or on an annual basis, it is recommended that a thorough visual
inspection of the bar is carried out, making sure that all bolts and other components are torqued to the
correct specification. Also check that all wiring sheaths, connectors, and fittings are free of damage.
Replace any components as necessary. This service can be performed by your local authorised ARB
stockist.
FITTING REQUIREMENTS
REQUIRED TOOLS FOR FITMENT OF PRODUCT:
Metric socket and spanner sets 8-25mm range
External Circlip pliers
Screwdrivers Philips and Flat blade
Cold chisel
Hammer
Power Drill 13mm capacity
10mm and 13mm drill bits
HAVE AVAILABLE THESE SAFETY ITEMS WHEN FITTING PRODUCT
:
Protective eyewear
Hearing protection
NOTE: ‘WARNING’ notes in the fitting procedure relate to OHS situations, where to avoid a
potentially hazardous situation it is suggested that protective safety gear be worn or a safe work
procedure be employed. If these notes and warnings are not heeded, injury may result.
FASTENER TORQUE SETTINGS:
SIZE
Torque Nm
Torque lbft
M6
9Nm
4lbft
M8
22Nm
16lbft
M10
44Nm
32lbft
M12
77Nm
57lbft
OPTIONAL LIGHT SETS TO SUIT THIS PRODUCT:
i ARB 6821201 FOG LAMP SUIT 3163015
i Up to IPF 900 SERIES FOG OR DRIVING LIGHT SETS