ARB WINCH BULL BAR - Manual (Page 11)

Last Rev Date: 11/05/2009 Page 11 of 13 Fitting instructions# 3786410
Copyright © 2005 by ARB Corporation Limited. All rights reserved, this document must not be reproduced without the express authority of ARB Corporation Ltd
38. Replace 21W light bulbs for indicator (yellow
reflector side) in supplied indicator/run lamp
assemblies with 10W bulbs from fitting kit.
39. Assemble and install combination light
surrounds (p/n 3163015) as per instructions
no. 3786421 supplied with surround kit. Note:
Optional fog lamps can be installed at this
point as per fitting instruction no. 3783315
supplied with fog lamp kit 6821201
40. Wire up indicator and run lights using loom
extensions supplied in fitting kit.
NOTE: The 4 Runner has a two wire circuit for
indicators. The bull bar indicator and run
lamps each side are to be wired to operate in
parallel. ARB supplied wiring loom has Red
and Green for power to indicator and run lamps
– join these wires together. Other wiring detail
supplied with accessories.
Toyota 4 Runner wiring colors:
RH White w/Black Stripe – Ground
Red w/Yellow stripe - Power
LH White w/Black Stripe – Ground
Red w/Green stripe - Power
FITTING PROCEDURE