Heater Craft 700 Yamaha Rhino - Manual (Page 7)

VENTS AND HOSE ROUTING cont.
Using a 2.00” hole saw, cut an opening in the Driver’s side
angled wing of the console 5.50” from the top and 5.00” from
the side. Insert the provided 2.00” round vent and snap into
place.
Using the same 2.00” hole saw, cut an opening in the
Passenger’s side angled wing of the console 2.00” from the
side and 5.50” from the top. Insert the remaining 2.00” round
vent and snap into place. Cut adequate lengths of 2.00’ hose
and route hose from installed vents to the remaining two
exhaust ports on the heater unit.