BNC 630 - Manual (Page 67)

62
7.8.3 Digital Format
The Digital format was implemented as an easy way to design purely digital waveforms, i.e. waveforms that are either high or low.
The digital format provides a very efficient way of representing waveforms that assume only a high or low value.
If the value of the data point is 0, then the SIG Out output is set to its minimum negative output voltage and the SYNC Out output is
set to the logic Low state (0V) for that point.
If the value of the data point is non-zero, then the output is set to its maximum positive output voltage and the SYNC Out output is
set to the logic High state (+5V) for that point.
All rules for this format are identical to those for Floating Point Format, except that the Time or Point Number value need not be
between +1.0 and -1.0 in value since the 630 only sees if the value is zero or nonzero. Also, the “P” character has no meaning since
the SYNC Out output is controlled by the data itself.
With this format, it is possible to specify each point of a digital waveform with only two bytes (a “1” or a “0” and a data separator
character). This makes this format as efficient as binary format for data downloads. However since the data consists entirely of
ASCII characters, it is easier to work with than binary format.
Example
This twelve point digital waveform
0 1 0 0 1 1 0 0 0 1 1 1
will render the following waveform on both the SIG Out and SYNC Out connectors: