BNC 630 - Manual (Page 8)

3
1.2 Feature Summary
••
Each unit is individually calibrated to ensure accurate output frequency, level, and offset voltage.
••
Output level: 4 mVp-p to 20.0 Vp-p (unloaded). Output level can be entered with 1 mV or .1 dBm resolution.
••
Output offset: 0 mV to +/- 12.0 V (unloaded). Output offset can be entered with 1 mV resolution.
••
TTL/CMOS compatible logic output drives digital circuits directly.
••
Flash Memory is used for code storage to enable easy software updates.
••
10 complete instrument setups can be individually stored or recalled.
••
Unit has a large, easy-to-read illuminated LCD display which shows all operating parameters for each setup. No confusing
submenus.
••
Full numeric keypad and rotary encoder make entering and adjusting parameter values easy.
••
Standard RS232 port included. Remote control operation requires no special hardware or software. Baud rate is programmable.
All commands use ASCII characters. Programming examples are included.
••
External modulation input is wideband: DC to 35 KHz. High input impedance (30K ohm) avoids loading the source signal.
••
External logic input allows user to gate output signal on/off under logic control. It can also be used as an external trigger signal.
External FSK and BPSK data is also brought in on this connector.
Modes
••
Basic Sinewave
•
DTMF Generation
••
Internal/External AM
•
DTMF Detection
•
Internal/External FM
•
Voltage & Power Measurement
•
Internal/External PM
•
Burst (Continuous or Int/Ext trig)
•
Internal/External SSB
•
Sweep
•
Internal/External BPSK (Linear/Log/Continuous/Triggered/Up/Down)
•
Internal/External FSK
•
Dualtone Generation
•
Data Modulation
•
Voltage Controlled Oscillator (VCO)
Options
(contact factory for availability):
•
High stability timebase
•
DC Operation