Hornady Lock-N-Load Rifle Bullet Feeder - Manual (Page 15)

Load
Put a case in the shell holder and cycle the press ram. The
bullet in the Alignment Sleeve (49) will seat into the case.
Simultaneously the Feed Block (58 or 59) will rotate and drop
a bullet.
Note: The first stroke of the press will not seat a bullet if
there isn't a bullet in the Alignment Sleeve (49).
When the ram is lowered, the bullet will slide down the Bullet
Ramp (66), push aside the Seating Stem (43), and drop into
the Alignment Sleeve (49). The Bullet Retaining O-Ring (50)
will hold the bullet in preparation for the next press cycle.
Subsequent cycles will simultaneously seat a bullet and feed
the next bullet.
Make smooth, consistent press strokes.
Partial press cycles may or may not feed a bullet and
jamming may occur.
If the press is double stroked and a bullet is not seated,
two bullets could be fed into the die. If in doubt,
disassemble the die and clear any bullets out of the die
before proceeding.
Be certain the die is clean so the bullets can slide past the
seating stem and drop into the alignment sleeve.
26
27
28
26
27
Bullet Path
- 15 -