Hornady Lock-N-Load Rifle Bullet Feeder - Manual (Page 4)

Hopper Installation
and Setup
Support Tube Installation
Place the Hornady ® Lock-N-Load ® AP ™ template (located
in the back of the manual) on the table in the location you
would like to mount the press and the Lock-N-Load
® Rifle
Bullet Feeder. Drill ¼" holes for the placement of the Bottom
Support Tube (36).
Use ¼" bolts with ¼" flat washers (Not provided, due to the
varying thicknesses of tables) on top of the Bottom Support
Tube (36) and also one on the bottom of the bench. Tighten
snug.
Place a ¼-20 x 2.5" Carriage Bolt (39) into each of the
square holes of the Top Support Tube (37). Slide them through
the slot on the front side of the Bottom Support Tube (36).
Place a ¼" Washer (30) and ¼"-20 Wing Nut (25) on each
¼"-20 x 2.5" Carriage Bolt (39). Snug the wing nuts finger
tight. The height will need to be adjusted at a later time.
1
2
3
1
2
3
- 4 -