Hornady Lock-N-Load Rifle Bullet Feeder - Manual (Page 9)

Lock Ring
Feeder Clamp
Die Body
Feeder Body
Bullet Ramp
Feeder
Support
Bracket
Compression
Spring &
Dowel Pin
Pan Head
Screw
Thumb Screw
Bullet Drop Adjustment
Loosen the Lock Rings (44) and adjust the height of the Feed
Tube Retainer (53) approximately 1/16" above the bullet tip.
Adjust location of the Feed Tube Retainer (53) so the bullets
drop freely into the Feeder Block (58 or 59).
NOTE: If the bullets don’t drop freely, the Feed Support
Bracket (54) can be slightly adjusted by loosening the Pan
Head Screws (56).
Refer to photo 16A.
Feeder Body Removal
16A: Loosen the Thumb Screw (41) and slide the Feeder
Clamp (40) up. The Feeder Body (63) will detach from the Die
Body (51).
NOTE: The Bullet Ramp (66) and Compression Spring (64) will
slide out of the bottom. Do not lose these).
16B: Set this assembly aside for attachment after die
adjustment.
NOTE: The Bullet Ramp (66) may slide out of the Feeder Body
(63). If this happens reassemble according to the drawing.
15
16
15
16A
16B
1/16"
Feed Tube
Retainer
Feeder Block
- 9 -