Burley Solo ST - Manual (Page 4)

Installing Tow Bar Clamps
1. On left front corner of trailer, match hole in left clamp
to hole in tow bar mount and insert bolt from the top
through holes.
2. Using hex key wrench on top and socket wrench on
bottom, tighten nut securely on bolt end. PHOTO 1
3. Repeat process to install right clamp on right front corner.
Opening and Closing Your Trailer
1. Rotate front tube upward and rear tube back until they
meet on plastic saddles. FIGURE 1
2. Rotate frame locks and snap onto rear tube. FIGURE 2
3. To close trailer, unclip seat buckles on back of seat and
reverse opening process.
NOTE: To allow folding, the side battens in the d’lite ST trailer
are not attached to the sides in the rear.
To view a video clip of “Folding a Burley” go to: www.
burley.com/support/tutorials.cfm.
PHOTO 1: Left trailer side
FIGURE 1
FIGURE 2
4 B U R L E Y D ’ L I T E S T A N D S O LO S T O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L
CHECK THAT THE FRAME LOCKS ARE PROPERLY ENGAGED
BEFORE USING THE TRAILER. FAILURE TO DO SO CAN RESULT IN
SERIOUS INJURY.
WARNING
TRAILERS CAN TIP OVER, CAUSING DAMAGE TO TRAILER AND
SERIOUS INJURY TO PASSENGERS. AVOID CAUSES OF TIP OVER,
ESPECIALLY:
• CHILDREN LEANING OR BOUNCING
• HITTING POTHOLES, CURBS, OTHER ROAD OBSTRUCTIONS
• TAKING TURNS TOO FAST
• SUDDEN SWERVING
• IMPROPER WHEEL INSTALLATION OR TIRE INFLATION
WARNING
Button
Bolt
Tow Bar Clamp
Frame Locks
Front
Rear
Tow Bar Mount
Plastic Saddles