Burley Solo ST - Manual (Page 6)

Using Parking Brake
Engage parking brake by pushing handle to the right. Exercise
caution when disengaging brake, as it may spring to the
left.
PHOTO 5
Installing Tow Bar
1. On left side of trailer, depress buttons on top and bottom
of tow bar clamp and swing clamp partially open.
NOTE:
When installing tow bar, do not swing the clamp all the
way open. PHOTO 6
2. Slowly slide tow bar into tow bar mount until the detent
clicks into place. PHOTO 6
3. Pull on tow bar to check that it is completely locked
in place.
4. Install retaining pin. PHOTO 7
5. Close clamp firmly, making sure clamp latch is
engaged. PHOTO 7
6. To remove tow bar, remove retaining pin, pull clamp all the
way open and slide tow bar out of mount. PHOTO 8
Burley Jogger and We! Ski can add to your trailering fun! Go
to www.burley.com to check out the Burley accessory kits
available for your trailer.
To install the tow bar when using these accessories:
For the Burley Jogger and We! Ski Kits, follow the
instructions above.
PHOTO 5
PHOTO 6: Install tow bar
PHOTO 8 : Removing tow bar
6 B U R L E Y D ’ L I T E S T A N D S O LO S T O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L
NEVER OPERATE TRAILER WITHOUT TOW BAR CLAMP LOCKED IN
PLACE. AN UNLOCKED TOW BAR CAN LOOSEN OR DETACH,
CAUSING ACCIDENT RESULTING IN SERIOUS INJURY.
WARNING
Brake Handle Engaged
Detent
Tow Bar
Slide In
Tow Bar
Mount
Button
Tow Bar
Clamp
PHOTO 7: Lock tow bar in place
Tow Bar Clamp
Button
Tow Bar Mount
Close
Tow Bar
Tow bar clamp in open position
Button
Tow Bar
Mount
Open
Tow Bar
Slide Out
Brake
Clamp Latch
Retaining Pin