Burley Solo ST - Manual (Page 9)

Installing Seat Pads
Match hook and loop fastening strips on trailer seat to back
side of seat pad.
Installing Shoulder Harness and Crotch
Strap Pads
Insert shoulder straps through loops on shoulder harness
pads, with straps oriented so that FLAT sides of strap buckles
face each other. Slide crotch strap through crotch strap
pad.
PHOTO 15
Using Seat Harness
One Passenger:
NOTE: In two-passenger trailers, use inner shoulder straps and
crotch strap.
1. Place child in center of seat.
2. Snap shoulder straps into Y-buckle, with buckle positioned
at child’s sternum. Adjust straps so that child cannot move
too far forward in seat.
3. Fasten and adjust lap belt snugly. FIGURE 4
Two passengers:
NOTE: For two children, use both shoulder harnesses and two
outer crotch straps.
1. Seat first child on one side of seat.
2. Snap shoulder straps into Y-buckle, with buckle positioned
at child’s sternum. Adjust straps so that child cannot move
too far forward in seat.
3. Repeat for second child.
4. Fasten and adjust lap belt snugly. To remove children,
release lap belt and harness buckles. FIGURE 5
NOTE: For taller children, the seat harness can be adjusted by
moving the buckles on the shoulder strap webbing into
the helmet pocket area, above the horizontal elastic.
PHOTO 15
FIGURE 4
FIGURE 5
B U R L E Y D ’ L I T E S T A N D S O LO S T O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N UA L 9
ALWAYS SECURE CHILDREN WITH HARNESS AND LAP BELT
BEFORE USE. ONLY USE THIS SEAT IF YOUR CHILD IS CAPABLE OF
SITTING UPRIGHT ALONE. FAILURE TO DO SO COULD RESULT IN
ACCIDENT AND SERIOUS INJURY OR DEATH.
WARNING
IMPORTANT
SINGLE PASSENGER MUST BE SEATED IN CENTER POSITION.
IMPORTANT
DO NOT SLIDE SHOULDER STRAP ASSEMBLIES ABOVE
WEBBING STOPS.
Harness Pads
Seat Pad
Flat sides of
buckles facing
each other
Crotch Strap
with Pad
Harness Pads
Lap Belt
Lap Belt
Harness
Pads
Outer Crotch
Strap
Outer Crotch
Strap
Harness
Pads