AEM 30-3301 V2 Water Methanol Injection Kit HD Controller - Manual (Page 10)

Page 10
seconds, and then remain full for another 3 seconds before stopping. Repeat the “TEST” button
procedure until you are sure the system is free of any debris that may have been in the lines or
tank. Drain the water out of the tank and refer to the next section on installing the nozzle.
Nozzle Selection and Assembly
This injection kit includes three different sized injection jets that cover a very large range of
horsepower levels. Use the following chart to select the appropriate jet for your power level.
The kit comes with one medium nozzle already preassembled.
HP
Fuel Flow
N/A (.5
BSFC)
Fuel Flow
F/I (.7
BSFC)
W/M Flow
N/A
W/M Flow
5-10psi
Boost
W/M Flow
10-25psi
Boost
W/M Flow
25+psi Boost
150 788 1101 95 220 275 330
200 1050 1469 126 294 367 441
250 1313 1836 158 367 459 551
300 1575 2203 189 441 551 661
350 1838 2570 221 514 642 771 Nozzle
400 2100 2937 252 587 734 881 250
450 2363 3304 284 661 826 991 500
500 2625 3671 315 734 918 1101 1000
550 2888 4038 347 808 1010 1212 1000 + 500
600 3150 4406 378 881 1101 1322 1000 + 1000
650 3413 4773 410 955 1193 1432
700 3675 5140 441 1028 1285 1542
750 3938 5507 473 1101 1377 1652
800 4200 5874 504 1175 1469 1762
850 4463 6241 536 1248 1560 1872
900 4725 6608 567 1322 1652 1983
950 4988 6976 599 1395 1744 2093
1000 5250 7343 630 1469 1836 2203
The nozzles are serviceable and can be disassembled for cleaning. If you find excessive debris
in the screen, check your tank for contamination. When installing the screen it is only necessary
to be slightly tighter than finger tight. Do not over-tighten. The nylon washers are reusable but
a spare is included.
Pintle/Screen Assembly
Nozzle Body
Jet/Orifice
Nylon Washer