AEM 30-3301 V2 Water Methanol Injection Kit HD Controller - Manual (Page 7)

Page 7
Pump and Tank Install
Find a suitable location to mount the tank and pump. The tank
should be mounted such that it is below the injection point. The
tank and pump must be mounted in the same area. Pump may be
mounted on exterior of vehicle but should be mounted away
from wheel wells or other areas where it will come into direct
contact with water or road debris. Pump failures that have
clearly been caused by exposure to water/mud/debris will not be
covered under warranty. This includes but is not limited to, the bed
of a truck, and the inside of the fender wells. Find a location where
the pump will remain dry. Use 4 of the 8 supplied #8 sheet metal screws along with the 4 large
washers or the 5/16-18 bolts and Nylock nuts to mount the 1-gallon tank.
(Optional 5 Gallon Tank Install)
Before mounting the tank, check the area under the desired mounting location for fuel tanks,
fuel lines, or any other obstructions. Mount the tank in an upright level position as shown below.
Mark the four mounting points and drill with a 3/8” bit. Use the supplied 5/16-18 bolts, nuts, and
large OD flat washers for mounting the tank into your vehicle. IMPORTANT: Use the supplied
large OD washer to spread the load on the plastic mounting ears of the tank. DO NOT
OVERTIGHTEN! Nuts should just be snug; they are locking nuts and will not loosen. Over-
tightening will crack the plastic and cause leaks and void the warranty.
Note: All tanks are tested for leaks during assembly. A special
sealant adhesive is used to bond the plastic tank to the metal
fitting. DO NOT attempt to tighten the fitting any further!
The pump must be located in the same area as the tank and should be mounted at or below the
lowest fluid level height.