AEM 30-3301 V2 Water Methanol Injection Kit HD Controller - Manual (Page 18)

Page 18
Optional System Upgrades
Water/Methanol Injection FAILSAFE Device AEM P/N 30-3020/30-3020M
Actively monitors the entire flow curve independent of
pressure, continuously collecting flow vs. injection rate
data so that any deviation from your established flow curve
will trigger an alarm output that can be used to reduce
boost or timing, change maps, add fuel, trigger a two-step
or perform practically any action you choose to save your
engine. It is PC programmable (with USB connectivity)
which eliminates the guesswork when setting min/max
threshold parameters. HIGHLY RECOMMENDED for all
water/methanol injection systems
Water/Methanol Injection Flow Gauge
– AEM P/N 30-5141/30-5142
Displays flow rate data on a smooth moving needle-type gauge that
allows you to accurately monitor the status of your injection system
in real time. Available in max flow rates of 500 cc/min or 1000
cc/min with a black or white face. The AEM water/methanol
injection filter is HIGHLY RECOMMENDED when using this flow
gauge.
Water/Methanol Injection Filter
– AEM P/N 30-3003
Inline filter that uses a micronic mesh screen to filter out particles as
small as 40 microns. Allows a cleaner flow of water/methanol into
the injection pump, lines, and nozzles increasing overall system
longevity. Injection filter is HIGHLY RECOMMENDED when using
the AEM water/methanol injection flow gauge.
Additional Nozzle Kit
– AEM P/N 30-3012
Includes one nozzle body, two jet sizes, and the necessary hardware to run
a second nozzle in your injection system.
5 Gallon Tank – AEM P/N 30-3010
Upgrade to a 5 gallon tank to maximize your fluid holding capacity.
Includes level sensor and mounting hardware.