AEM 30-3437 Series 2 AEMnet Adapter - Manual

AEM Performance Electronics
2205 W 126 th Street Unit A, Hawthorne, CA 90250
Phone: (310) 484-2322 Fax: (310) 484-0152
http://www.aemelectronics.com/
Instruction Part Number: 10-3437 Rev 1
 2011 AEM Performance Electronics, Inc.
Page 1
AEMnet
AEMnet is an open architecture software and hardware interface based on the CAN 2.0 specification,
which provides the ability for multiple AEMnet enabled devices to easily communicate with each other
through a single cable. The hardware connection is made through a Deutsch 4P DTM connector.
Devices connected to the AEMnet transmit data through this one connection. Once the AEMnet
adapter is installed, the Series 2 EMS will be able to send and receive data on the AEMnet.
Instructions for configuring the Series 2 EMS to output data are included in this manual. Instructions
on configuring the Series 2 EMS to receive data from other AEMnet enabled products are contained
in the individual product manuals. Upon completion of these instructions, the Series 2 EMS will be
configured to output data to an AQ1 Data Logger or other data receiving device.
The following AEM products are currently AEMnet enabled:
Series 2 Engine Management System
EMS-4 Universal Standalone Engine Management System
4-Channel Wideband UEGO Controller
AQ-1 Data Logger
Dyno Shaft On-Vehicle Dynamometer
Instruction Manual
P/N 30-3437 AEMnet Adapter Harness Installation
for Series 2 EMS 30-6610 & 30-6611