Remove existing wires from ecu plug(s) – AEM 30-3437 Series 2 AEMnet Adapter User Manual
Page 3
Advertising
Page 3
REMOVE EXISTING WIRES FROM ECU PLUG(S)
1. Locate a small screwdriver (a precision 1.5mm wide flathead screwdriver is recommended)
and carefully pry gray plastic retainer using the three slots in the retainer so it disengages
vertically about 1mm as shown in figures 2 and 3:
Figure 2: Pry in these areas
Figure 3: Lock that has to move up
1mm
Advertising