AEM 30-3903 Infinity Plug & Play Harnesses - Volkswagen 2002-2005 MKIV Golf/Jetta 1.8T - Manual (Page 19)

Setup Wizard 19
© 2014 AEM Performance Electronics
Drive By Wire Wizard
The base calibration will set most of the Drive-By-Wire (DBW) channels for the stock VW 1.8T throttle body. If a
different throttle body is used (R32, Hemi, etc) then further adjustments to the DBW channels may be required. To
complete the DBW setup the Drive By Wire Wizard must be ran.
Select Calibrate sensor data only and follow the DBW Setup steps.
Note: There are a few integrated DBW fail safes incorporated into the Infinity system. For instance, if the
accelerator pedal and throttle position sensors do not track each other, or if the maximum DBW current is
exceeded, there will be a fatal error which will enable the DBW Error Rev Limit (the rev limit is adjustable in the
DBW Tuning section of the Setup Wizard) for safety purposes. This error will reset when the ignition key is cycled
or if the problem is fixed. Additionally, the 1.8T base session is setup with brake override enabled. The Brake
Throttle Override kills the engine if the accelerator and brake pedals are pressed at the same time under certain
conditions.