Bunn JDF-2N - Manual (Page 25)

25 38310 010406
TROUBLESHOOTING (cont.)
Water leak filling drip tray or around
dispense deck area
Water leaking beneath machine
Erratic spray during dispense
Dispense nozzle dripping water
Can't access programming
1. Initial fill/setup
2. Dispense deck
3. Water pressure greater than
100psi
1. Bath tank overflow.
2. Condensation from cabinet cool-
ing coil.
Dispense nozzle mixer missing or
broken
Dispense solenoid.
Programming password feature
activated.
Dispense touchpad
Some expansion normal. May fill
drip tray during initial ice block
formation
Inspect or replace fittings clamps,
o-rings, solenoids and quick discon-
nect fittings.
NOTE: Dispense deck area slopes
to drain tube that leads to the drip
tray.
Install water pressure regulator and
reduce to 50 psi.
A) Bath fill valve - check for closed
position or replace leaking valve
B) Check all internal water connec-
tions.
Check for routing of condensation
tube to drip tray.
Replace mixer.
Replace dispense deck solenoid.
See Password Protection to access
programming or reset password
to zero or change programming
password.
Check for continuity on half and full
moon buttons. If no continuity when
pressed, replace touchpad.
PROBLEM PROBABLE CAUSE REMEDY