Apple LaserWriter 12/640 PS - Manual (Page 58)

13 Select the LaserWriter 12/640 PS and click Install.
The PostScript printer driver files and other software are installed on the hard
disk. A message appears telling you that the driver software was successfully
installed.
14 Click OK to dismiss the message.
15 Select another Apple LaserWriter printer, if you want, and click Install to install. Repeat
for each printer you want to install.
You can install other Apple LaserWriter printers supported by the software.
16 When you’re done, click Close.
A message appears telling you to use the Printers control panel to connect
and set up the printers you’ve installed. By default, each printer uses LPT1.
The Printers control panel Setup dialog box lets you specify a different port,
for example, LPT2, or a NetWare queue.
17 Click OK to dismiss the message.
Installation is complete.
18 Choose how to proceed:
For users connected via the parallel cable, the default printer driver settings
should suffice.
For instructions on using the Apple LaserWriter Utility for Windows, see
Appendix A.
To configure your printer software with NetWare, see “Initial Novell
NetWare 4.1 Setup,” later in this chapter.
58 Chapter 3