Advanced system functions – CompuSTAR RF-2W940-SS (Remote 2W940R-SS) User Manual
Page 11
21 By Firstech, LLC
Advanced System Functions
Tap buttons simultaneously for a half second to turn drive lock on and off (also known as ignition controlled door locks).
The vehicle’s parking lights will flash once and/or siren chirp once to confirm drive lock is on. The vehicle’s parking lights will flash twice and/or siren chirp
twice to confirm drive lock is off.
IMPORTANT: Drive lock mode requires that the dealer turn on Option 1-9. Drive lock has two settings;
Default 1: Off
Option 2: Locks the doors when the ignition is on and after the brake is depressed.
Option 3: locks the doors when the RPM’s have reached two times that of idle speed (this setting requires that a tachometer wire is connected).
With both settings, the doors will unlock when the ignition is turned off. If using this feature on a manual transmission vehicle, the doors will unlock
upon setting the emergency / parking brake.
The following section reviews advanced system functions. Many of these functions require multiple steps or additional programming by your local
authorized Firstech dealer to be active.
d @l@O@@c @d@l
This feature can not be turned on with the 2 Way remote. The built in turbo timer keeps the vehicle’s engine running for either 1, 2, or 4 minutes
(programmable from dealer) after the vehicle key has been removed from the ignition. This feature will keep oil running through the turbo system to allow
for appropriate cooling time. Tap buttons simultaneously for a half second to turn on or off turbo mode. The remote will beep once and the
lock and start icons flash to confirm that turbo mode is activated. The remote will beep twice and icon will disappear to confirm turbo mode is off.
IMPORTANT: To utilize this feature, the emergency / parking brake wire must be connected to the Firstech system. Consult your local authorized dealer
for installation.
t@t @m
By Firstech, LLC 22
Advanced System Functions
This remote has the ability to operate a 2nd vehicle with the same system.
Note: When in 2nd Car Mode that your Lock and Unlock LEDs will flash purple when the buttons are tapped. Hold buttons for 2.5
seconds to enter the Remote Option Menu. Tap the Trunk Button to turn 2nd Car Mode on. Your remote will chirp once for on and twice for
off. The remoteᴗs Trunk LED will illuminate blue confirming that 2nd car mode is activated. The remote will remain in 2nd Car Mode until you hold the
buttons for 2.5 seconds, enter the Remote Option Menu and tap the Trunk Button. The remote will beep twice and you must hold
the Unlock and Trunk buttons to save the Remote Option Menu changes.
IMPORTANT: 2nd car mode requires the remote to be programmed to a 2nd vehicle that is equipped with the same remote kit.
R
c@m @Hm @v @cI