Advanced system functions, Remote coding / programming routine (s) – CompuSTAR RF-2W940-SS (Remote 2W940R-SS) User Manual
Page 14
27 By Firstech, LLC
Advanced System Functions
Timer start mode is used to cool or warm the vehicle automatically without use of the key or the remote. While engaged, timer start will activate even
while the remote is out of range. Tap buttons simultaneously for a half second to activate timer start mode. The remote will beep once
and LEDs flash once. Repeat the same step to turn off timer start mode. Timer start mode will be cancelled any time the vehicle is started manually or
remotely. To change from the default setting to optional settings, see your place of purchase.
t @s@m
Cold/hot start mode works in conjunction with timer start mode (see above) and the temperature sensor. It allows you to configure your timer start
feature to check the vehicle’s temperature prior to starting. All of these options require programming from your local dealer.
c@O@h@s@m
a@j@m
Your system has a mode that requires you to keep your remote separate from your key chain. This feature also requires additional labor. Please consult
your installer for more details. The Anti Jacking mode allows you to safely disable your vehicle once a thief has driven off with your property. If you are car
jacked and still have your remote, you can panic the system by holding button down for 3.5 seconds. The siren will sound for 30 seconds and the
vehicle will shut down.
m @o@s
If you purchased an Alarm or Alarm and Remote Start system you have the ability to add optional sensors from Firstech, LLC. You have the ability to
protect your investment by adding a battery back up system to protect main power to your alarm or a tilt sensor to protect expensive rims and tires.
By Firstech, LLC 28
p@Z@R@w@T@b@r Z
STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between the Acc & On positions) five times within 7 seconds.
The vehicleᴗ
s parking lights will flash once with the successful completion of this step.
STEP 2: Within 2 seconds after cycling the ignition for the 5th time, tap the Lock button on 2 way remotes or the (lock) button on 1 way remotes
for a half second. The parking lights will flash once to confirm the transmitter has been coded.
Exiting Programming: Programming is a timed sequence. The parking lights will flash twice signaling the end of
programming mode.
Programming Multiple Remotes: After the confirmation flash given in step 2, code additional remotes by
pressing button on 2 way remotes or the (lock) button on 1 way remotes. The parking lights will flash once
confirming each additional remote. All systems can recognize up to three remotes.
IMPORTANT: Every Firstech remote must be coded to the system prior to performing any operations. All remotes must be coded at the same time.
Remote Coding / Programming Routine (S)