General system functions – CompuSTAR RF-2W940-SS (Remote 2W940R-SS) User Manual
Page 9
17 By Firstech, LLC
General System Functions
Cancelling Reservation Mode
Reservation mode will be cancelled for the following reasons;
You did not activate the parking brake prior to turning off the ignition.
You pressed the foot brake after the key was removed from the ignition.
You released the parking brake after the key was removed from the ignition.
You entered valet mode, opened the vehicle’s door, hood, trunk or set off the alarm.
Reservation Mode Settings
Reservation mode settings can be programmed with Option 1-6. It is recommended that reservation mode settings are programmed by your local authorized
Firstech dealer.
Default1 : Locks doors when reservation mode is set.
Option2 : Hold Key/Start button to initiate Reservation Mode.
Option3 : Reservation mode sets 10 seconds after the last door is closed, as opposed to immediately.
This option will allow you to access the vehicle’s rear doors, trunk or hatch prior to the system setting reservation and passively locking/arming.
Option4 : Shuts motor off before locking doors.
Hold button for 2.5 seconds to release the trunk or hatch. If you are in range, the remote will beep twice and the LEDs will flash indicating that the trunk
release command has been successfully transmitted.
IMPORTANT: Trunk release is an optional vehicle feature that may require additional parts and labor.
t@r
By Firstech, LLC 18
General System Functions
Your system is equipped with two additional outputs that can be configured to control windows, open power sliding doors, open a power sliding moon roof, or
even turn on a rear defroster. These outputs can be configured for pulsed, timed or latched settings. Your authorized Firstech dealer can set these outputs up
accordingly. Using auxiliary outputs to control additional vehicle functions will require additional parts and can be rather labor extensive.
Tap button for a half second to trigger auxiliary output 1. Tap button for a half second to trigger auxiliary output 2. The vehicle’s parking lights
will flash once and/or siren chirp once indicating that the auxiliary outputs have been triggered.
By default, the system is in secure auxiliary mode, which requires you to hold button for 2.5 seconds prior to triggering auxiliary 1 or 2.
To turn off secure auxiliary, ask your authorized Firstech dealer to turn on Option 4-5 to setting II.
a@o@O@w@rMd@O@s@d
Upon lock/arm and unlock/disarm, you can eliminate vehicle’s audible confirmation by muting the siren. Normally, the siren will chirp once to indicate
the system is locked/armed and twice to indicate the system is unlocked/disarmed. To mute the siren tap buttons simultaneously for 0.5
second. When the siren is muted, the siren icon will no longer be displayed on the LCD.
IMPORTANT: Even when the siren is muted, it will still go off in the event the alarm is triggered.
s @a@O@d