Lukas LSI Series Cutter - Manual (Page 3)

3
1 Basic operation and designated use of the machine
1.1 The machine has been built in accordance with state-of-the-art standards and
the recognized safety rules. Nevertheless, its use may constitute a risk to life and limb
of the user or of third parties, or cause damage to the machine and to other material
property.
1.2 The machine must only be used in technically perfect condition in accordance
with its designated use and the instructions set out in the operation manual, and only
by safety-conscious persons who are fully aware of the risks involved in operating the
machine. Any functional disorders, especially those affecting the safety of the machine/
plant, should therefore be rectifi ed immediately!
1.3 The machine is exclusively designed for the use described in the operating manual.
Using the machine for purposes other than those mentioned in the manual, such as
driving and controlling other pneumatic systems, is considered contrary to its designated
use. The manufacturer/supplier cannot be held liable for any damage resulting from
such use. The risk of such misuse lies entirely with the user.
Operating the machine within the limits of its designated use also involves observing
the instructions set out in the operating manual and complying with the inspection and
maintenance directives.
2 Organizational measures
2.1 The operating manual must always be at hand at the place of use of the
machine!
2.2 In addition to the operating instructions, observe and instruct the user in all other
generally applicable legal and other mandatory regulations relevant to accident prevention
and environmental protection.
This also applies for wearing protective clothing, helmet with visor or goggles and
protective gloves.
2.3 In order to avoid innjuries, the machine must only be operated by a specially
trained operator who has undergone a safety training.
2.4 Observe all safety instructions and warnings attached to the machine. Make sure
that safety instructions and warnings attached to the machine are always complete and
perfectly legible.
2.5 Never make any modifi cations, additions or conversions which might affect safety
without the supplier‘s approval. This also applies to the installation and adjustment of
safety devices and valves.
2.6 Spare parts must comply with the technical requirements specifi ed by the
manufacturer. Spare parts from original equipment manufacturers can be relied to do so.
It is only allowed to use original LUKAS spare parts of LUKAS system components.
2.7 Replace hydraulic hoses at the specifi ed or adequate intervals, even if no defects are
detected which might affect safety. This must be done after 10 years, at the latest!
2.8 Adhere to prescribed intervals or those specifi ed in the operating manual for routine
checks and inspections.