Lukas LSI Series Cutter - Manual (Page 4)

4
3 General safety instructions
3.1 In the event of malfunctions, stop the machine immediately and lock it. Have any
defects rectifi ed immediately.
3.2 Before starting up or setting the machine in motion and during operation of the
machine make sure that nobody is at risk.
3.3 It is strictly forbidden to get a part of the body between the blades of the device!
There is the danger of cutting!
3.4 Consider that no hair and protective clothing parts come into the proximity of the
mobile parts, it could be drawn in!
3.5 Grab the equipment only at the intended grasps, in order to avoid squeezings
3.6 Do not store the equipment in the proximity of heat sources! The equipment is
thermally well conductive and the consequence could be that the User can get light
burns!
3.7 Consider the maximally permissible pressure. This is noted directly on a label on
the equipment.
3.8 Before transporting the machine always check that the accessories have been
safely stowed away.
3.9 Make sure that there is enough lighting during work.
3.10 Avoid any operation that might be a risk to the user and/or the machine stability.
3.11 Check the machine at least after every operation for obvious damage and defects.
Report any changes (incl. changes in the machine’s working behaviour) to the competent
organization /person immediately. If necessary, stop the machine immediately and lock
it. All lines, hoses and screwed connections have to be checked for leaks and obvious
damage. Repair damage immediately. Splashed oil may cause injury and fi re.
3.12 All safety equipment has to be checked for completeness and fl awless condi-
tion:
- instruction markings and warning signs (safety instructions),
- check safety cover (e.g. motor-safety covers, heat protection etc.) if they are avail-
able and
if they are in good condition.
3.13 Do not stress hoses mechanically (pulling, buckling etc.).
3.14 Touch the cut off parts only with protective gloves, because the cut edges are very
sharp.
3.15 The cutting tool may not be served in drunk, druggy or similar conditions. Otherwise
there is the danger that situations are misjudged.
3.16 Parts under mechanical stess may only be cutted, when you have secured them