Synergy 5410 - Jeep JK Front Bumper User Manual
Ppm-8410 jk front bumper install instructions
SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-8410 JK FRONT BUMPER INSTALL
INSTRUCTIONS
Version 1
GENERAL NOTES:
• These instructions are also available on our website; www.polyperformance.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• The Polyperformance JK front bumper system is a bolt on installation but does
require minor trimming and cutting with a sawzall or cut off wheel.
• The winch mount requires the use of a hawse fairlead, a roller fairlead does not
fit in the bumper.
1. Remove the splash shield and disconnect the fog light connectors if equipped.
Remove the stock bumper, tow hooks and upper frame trim.
2. Loosely install the new Poly Performance front bumper using the carriage head
bolts. The lower outer hole of the front frame bumper mounting plate needs to be
trimmed with a sawzall or cut off wheel. Mark the frame plate along the weld on
the backside of the bumper and trim.