Synergy 5410 - Jeep JK Front Bumper - Manual (Page 12)

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
16. Position the rear stabilizer bar bolt spacer between the skid plate and stabilizer
clamp. Loosely install the new M10 x 90 bolts and use a 3/8” flat washer. Do not
tighten yet.
17. Install the four 3/8 x 3/4” long bolts thru the front of the skid plate and into the
tabs in the bottom of the bumper. You may need a tapered alignment bar to align
the holes in the skid plate to the tapped holes in the bumper tabs. When all the
bolts are installed, tighten to 20 ft-lbs.
18. Tighten the rear M10 bolts in the stabilizer clamps to 45 ft-lbs
19. Tighten the ½” side bolts to 60 ft-lbs
20. Installation of the bumper, winch mount and skid plate is complete.
End