Synergy 8020-20/8040-20 - Jeep JK 2 - Manual (Page 11)

30) Once coil springs are installed, install shock absorbers.
 If reusing factory shocks, we suggest using PPM-8015 front shock mounts. Reference
the 8015 instructions at this time if factory shocks are being retained
 If factory shocks are being replaced with upgraded units spec’d for up to 2” of lift, install
into factory locations using the steps below for reference.
31) Install shock absorbers. Use images below for reference. Install into upper mount first. Tighten upper
nut until bushings begin to bulge out. Do not exceed 20 ft-lbs of torque.
 Note, on 2012+ models, some trimming of inner fender plastics will make for an easier
time when installing the front shocks. See IMG 14.2 below