Synergy 8020-20/8040-20 - Jeep JK 2 User Manual
Page 4
Advertising
IMG 5.1
IMG 5.2
6) With shocks removed, carefully lower the axle to allow for coil spring removal.
Take careful note of all electrical connections going to the axle. Make sure these will not
be strained as axle is lowered. Disconnect / remove fasteners as needed to allow for coil
removal.
7) Install 8058-20 rear bump stop spacers. Position the spacers on top of the factory bump pad so they lean
forward. Install using the hardware provided. Be sure to use a washer under the bolt head only. Torque
3/8” bolts to 40 ft-lbs.
Advertising