JLG 3246E2 ANSI Operator Manual - Manual (Page 30)

SECTION 3 - USER RESPONSIBILITIES AND MACHINE CONTROL
3-4
– JLG Lift – 3120736
5. Steer Switch
The thumb-operated steer switch, located on top of
the joystick controller, activates the steer wheels in
the direction the switch is moved (left or right).
DO NOT USE HIGH DRIVE SPEED WHEN DRIVING IN CLOSE
QUARTERS OR WHEN DRIVING IN REVERSE.
6. Drive Speed Select Switch
The speed select switch is a toggle switch which
allows you to select high or low speed.
NOTE: The High Drive Speed switch will cut-out when the
platform is raised above the stowed position, return-
ing drive speed to low until the platform is lowered
completely
DO NOT OPERATE MACHINE IF HIGH DRIVE SPEED OPERATES
WHEN PLATFORM IS RAISED ABOVE THE STOWED POSITION.
NOTE: The machine is equipped with a Pothole Protection
System which lowers automatically when the plat-
form is raised. The Pothole Protection System will
also lower when either of the doors are opened, but
only on the side of the opened door and this will not
provide tip over protection. If the Pothole Protection
System does not fully lower, the DRIVE function is
cut out until the platform is completely lowered.
1. Tilt Alarm Warning Horn
The Tilt Alarm Warning is activated by the Tilt Alarm
Switch when the chassis is on a severe slope and
lifted above stowed position.
1532E2/1932E2/2032E2 - 1.5°
2632E2/2646E2/3246E2 - 2°
All Japanese Models - 5°
IF TILT ALARM IS ON WHEN PLATFORM IS RAISED, LOWER
PLATFORM COMPLETELY, THEN REPOSITION MACHINE SO
THAT IT IS LEVEL BEFORE RAISING PLATFORM.
Figure 3-2. Platform Control Station