IOGear GWHDMS52MB - Manual (Page 18)

18
Step 4: Mounting the Receiver to a Wall (Optional)
1. Refer to the drawing at the right that has a
relative position of the main holes that will
be needed to be drilled into the wall.
2. Drill two ¼” pilot holes.
3. Insert the supplied two Anchors into
the wall. If necessary, use a small
hammer to lightly tap the anchors
flush to the wall.
4. Insert two screws into the anchors.
Leave ¼” length for mounting the
Transmitter, 5/8” for the Receiver.
5. Place receiver main holes over the
protruding screws and slide down into
position